Replacing the stock shifter in your SRT-4 requires the removal of the shift knob & boot, center console, and shift cables. This install should take no longer than an hour and requires simple hand tools.

Required Tools:
• 13mm socket
• Phillips screwdriver
• Large flathead screwdriver
• Pliers

Remove Center Console

Remove the stock shift knob by pulling up. You may have to engage 4th gear then pull towards the dome light. Now remove the shifter boot by prying on the sides with your hands and pull up. Both of these items should be remove without the use of any tools.

There are 6 screws on the center console. Each front cup holder contains a Phillips screw, remove them. The 4 remaining screws can be found inside the center console compartment, remove them using a Phillips screwdriver.

Engage the emergency/parking brake as far as you can. You can now remove the center console by pulling up and back. I find it easier to rest the entire center console on the back seat while working on the shifter.

Remove Stock Shifter

There are 2 clips holding the shifter cables on each side of the shifter. Without damaging the cables, use a large flat head screwdriver or pliers to remove the clips. You may also employ a hammer while using the base of the shifter as leverage, but I will leave this up to you.

The cables are also connected to the shifter with a bushing on each side. You can 'snap' them out of the shifter studs by pulling on them. Depending on how hard they are to pull out you may be able to use your hands or employ a tool, just be careful and do not break them.

You are now ready to remove the shifter. Use a 13mm socket to remove the 4 bolts securing the shifter, 1 per corner. Pull shifter up and out of the studs. Now pull back until the cables slide out, then move them to the side and remove the shifter from the car.

Install New Shifter

Installing your new shifter is a simple matter of reversing the previous steps.

Slide the cables in through the side of the slots, now move the shifter towards the front of the car and slide the cables in place.

Locate the 4 studs and drop the shifter in place, use the 13mm bolts to secure the shifter.

Install the bushings on each side of the shifter by pushing on them. Now install the clip on each side of the shifter to secure the cables. You may use a small hammer to tap them in place.

Slide the center console back into place by making sure the emergency/parking brake and shifter fit through the slots. Use the 6 screws to secure the center console.

Install the shifter boot and knob. You're all done.